Group: SGS Gas 5% Argon Mix

Store cylinders in an upright position in a secure, well-ventilated location away from sunlight and heat. Keep them restrained or secured to avoid falling, and have valve caps in place when they are not being used.

This mixture is suitable for use with most MIG welding machines. However, make sure that your regulator is suited for this gas mixture and that fittings all match up properly and are in good condition.

Make sure you have good air circulation while welding. Store cylinders in an upright position and away from heat in a location with clean air. Always use the correct regulators and check them for leaks before using.

How long it will last will depend on a number of factors including the flow rate, duty cycle, and cylinder volume. As a rule, a standard-volume cylinder at 15 litres a minute will provide around 8-10 continuous hours of weld time.

The mixture comes in many different cylinder sizes to meet different needs, ranging from small portable cylinders to bigger workshop sizes. Please call us regarding the availability of sizes and the rental policies.

Normal flow rates are between 12-15 litres per minute for most applications. This can be adjusted, however, depending on material thickness, welding position, and nozzle size. Begin at 12 litres and adjust as required for good coverage.

This mixture is specially formulated for mild steel welding. It can be used to weld 1mm to 12mm thick material, but may be used on thicker material if required. It is not the best choice for welding stainless steel or aluminium.

This mixture is a good combination of CO2 and Argon. It produces nicer-looking welds, reduces spatter, and welds more consistently. It is an especially good choice for sheet metal welding and general steel fabrication work.

This 5% Argon mix is formulated for MIG welding. It helps to create a stable arc and very good welds, especially for welding mild steel and thin metal where you need little spatter and deep penetration.